We seldom encounter the problem of Jinan cable bridge in our life, because we use Kaichen bridge, which has good technology, good quality and long service life.

如果電纜橋架的故障，常見的有以下四種類型;

If the cable bridge fails, there are four common types:;

1.整個電纜燒毀或某一相燒毀。這種類型的故障會導致配電柜上的電流繼電器工作。電纜在故障處嚴重受損。

1. The whole cable is burnt or one phase is burnt. This type of fault will cause the current relay on the distribution cabinet to work. The cable was seriously damaged at the fault.

2.電纜的所有相都短路了。類似地，這種類型的故障導致配電柜上的電流繼電器和電壓繼電器工作，并且電纜在故障點被嚴重損壞。

2. All phases of the cable are short circuited. Similarly, this type of fault causes the current relay and voltage relay on the distribution cabinet to work, and the cable is severely damaged at the fault point.

3.電纜橋只有一相開路，電流繼電器工作，故障點的損壞相對較輕但很明顯?？赡苁窍嚯娏鬟^大或由電纜質量引起的。

3. Only one phase of the cable bridge is open, the current relay works, and the damage of the fault point is relatively light but obvious. It may be caused by large phase current flow or cable quality.

4.電纜內部短路，外觀看不到痕跡，這類故障一般是由電纜質量造成的，比較少見。

4. There is a short circuit inside the cable, and no trace can be seen on the appearance. This kind of fault is generally caused by the cable quality, which is relatively rare.

由此可見，在選擇濟南電纜橋架時，我們需要找到強大的制造商。只有用好的技術才能造出高質量的橋梁，只有用好的質量才能使橋梁有長的使用壽命。

Therefore, when choosing Jinan cable bridge, we need to find a strong manufacturer. Only with good technology can we build a high quality bridge, only with good quality can we make the bridge have a long service life.

托盤電纜槽底部有許多腰形孔，便于散熱，廣泛應用于石油、化工、電力、輕工、電視、電信等領域。它具有重量輕、負載大、透氣性好、外形美觀、結構簡單、安裝方便等特點。它不僅適用于電力電纜的安裝，也適用于控制電纜的敷設。

There are many waist shaped holes at the bottom of tray cable trough, which is convenient for heat dissipation and widely used in petroleum, chemical industry, electric power, light industry, television, telecommunications and other fields. The utility model has the advantages of light weight, large load, good air permeability, beautiful appearance, simple structure, convenient installation, etc. It is not only suitable for the installation of power cables, but also for the laying of control cables.

線槽電纜槽是一個全封閉的電纜槽，不利于散熱。適用于鋪設計算機控制電纜、通信電纜、熱電電纜等高靈敏度系統，對控制電纜的屏蔽干擾和嚴重腐蝕環境下的電纜保護具有良好的效果。

Cable trough is a completely enclosed cable trough, which is not conducive to heat dissipation. It is suitable for laying computer control cable, communication cable, thermoelectric cable and other high-sensitivity systems, and has good effect on shielding interference of control cable and cable protection under severe corrosion environment.

階梯式索橋具有強度高、重量輕、成本低、外形美觀、安裝方便、透氣性好等特點。一般適用于敷設較大直徑的電纜，尤其適用于敷設高、低壓、大負荷的電纜。梯子的底部像一個樓梯，側面有擋板。在灰塵多的地方使用梯子，這樣灰塵就不會堆積。

Ladder type cable bridge has the characteristics of high strength, light weight, low cost, beautiful appearance, convenient installation, good air permeability, etc. Generally, it is suitable for laying cables with larger diameter, especially for laying cables with high, low voltage and large load. The bottom of the ladder is like a staircase, with baffles on the sides. Use ladders where there is a lot of dust so that the dust doesn't build up.

許多人在不知道如何安裝電纜槽時感到沮喪。

Many people are frustrated when they don't know how to install the cable tray.

(1)橋梁：各種類型和規格的橋梁總長度分別計算。除了橋的尺寸長度之外，還獲得了橋的數量，并增加了百分之1~2的附加余量。

(1) Bridge: the total length of various types and specifications of bridges shall be calculated separately. In addition to the size and length of the bridge, the number of bridges is also obtained, and an additional margin of 1-2% is increased.

(2)柱：如果采用相同規格的柱，可用橋框架的總長度除以統一的柱間距得到柱的數量，然后剩余的數量增加百分之2~4。如果列規格不同，則需要單獨的統計數據。

(2) Columns: if columns of the same specification are used, the number of columns can be obtained by dividing the total length of the bridge frame by the uniform column spacing, and then the remaining number can be increased by 2-4%. If the column specifications are different, separate statistics are required.

(3)支架：橋梁的總長度除以支架的均勻間距，然后增加百分之1~2的余量，即總需求量。

(3) Support: divide the total length of the bridge by the uniform spacing of the supports, and then increase the margin by 1-2%, i.e. the total demand.

(4)其他部分：將主要部分的數量乘以一定的比例(取決于工廠)以獲得總數。

(4) Other parts: multiply the number of major parts by a certain proportion (depending on the factory) to obtain the total number.

以上就是濟南電纜橋架常見的一些故障，以及電纜橋架的一些安裝方法，相信通過本文的描述，你能夠對電纜橋架有一定的認識和了解，希望以上內容內容能夠幫助到你。另外，若你想要了解更多相關資訊，可以多多關注我們的網站動態!

The above are some common faults of Jinan cable bridge and some installation methods of cable bridge. I believe that you can have some understanding of cable bridge through the description of this article, and hope the above content can help you. In addition, if you want to know more about it, you can pay more attention to our website!