Fiberglass reinforced plastic cable bridge because of its own stability, now the application is very much, the following Shandong cable bridge manufacturers will give you a brief summary of the installation requirements of fiberglass reinforced plastic cable bridge, I hope to help you!

1、電纜橋架與連接板的固定：每個連接孔內都應該擰緊螺栓，螺母漏在橋架的外面 。

1. Fixation of cable tray and connecting plate: bolts should be tightened in each connecting hole, and nuts leak out of the tray.

2、槽式電纜橋架伸出建筑物墻外時，它外向的傾斜角度不得小于1/100。

2. When the trough cable tray extends out of the building wall, its outward inclination angle shall not be less than 1/100.

3、電纜橋架與用電設備的凈間距不得小于0.5米，電纜橋架平行鋪設時，它的凈間距不得小于0.6米。

3. The net distance between the cable bridge and the electrical equipment shall not be less than 0.5 meters. When the cable bridge is laid parallel, the net distance between the cable bridge and the electrical equipment shall not be less than 0.6 meters.

4、電纜橋架應高出地面2.2米以上

4. Cable bridge should be 2.2 meters above ground level.

5、電纜橋架的頂部據頂棚的距離不得小于0.3米

5. The distance between the top of the cable bridge and the roof shall not be less than 0.3 meters.

6、電纜的填充率不應超過橋架斷面的50%。

6. The filling rate of cable should not exceed 50% of the bridge section.

7、電纜橋架的支持間距一般是1.5米-2米之間

7. The support spacing of cable bridge is generally between 1.5 m and 2 m.

8、電纜的鋪設傾斜角大于45度的，每隔2米固定一次。

8. If the inclination angle of cable laying is greater than 45 degrees, it shall be fixed every 2 meters.

以上便是今天由山東電纜橋架廠家為大家整理分享的精彩內容了，大家可以收藏我們的官網：http://www.12xw.com 來了解更多的前沿資訊，謝謝大家！

These are the wonderful contents that Shandong Cable and Bridge Frame Manufacturer has organized and shared for you today. You can collect our official website: http://www.12xw.com to learn more frontier information. Thank you!